Products tagged with spare parts

Sort by:

If you have ever used tape or films you will know that they are difficult to fit. LokBuild is more rigid and easy to apply to your build plate. Also, it is almost impossible for air bubbles to get trapped beneath the LokBuild surface.
Bearing Housing Bottom (#2022)
A solution for clogged nozzles? This sharp cleaning needle loosens the clogged residue easily. The needle was designed specially to resist the temperature of the print nozzle and the clogged materials.
Siliconce Nozzle Cover (#2161)
Are you looking for a 3D-printer, but you have no idea where to start? Take a look at our Ultimaker 2+ Starter pack.
€2.417,89 €2.294,99
Print Head Cable Ultimaker 3 Extended (#2187)
The Production + Scanner pack is one of our five value packs, which allows you to experiment, design and produce small batches fast and accurately
€9.892,32 €8.894,99
Capacitive Sensor Board (#2015)
Injection Moulding Set (Molded Parts) (#1030)
What is the most annoying part of printing in 3D? Probably cleaning your printbed. To make this easier, we present PrintaClean. This solution to clean your printbed allows you to easily remove the sticky residue.
The Ultimaker maintenance kit is a must have kit. All spare parts you need to maintain your Ultimaker can be found in this maintenance Kit.
TFM Isolator Coupler (#2278)
Thanks to the Adhesion sheets of Ultimaker, your prints will adhere to the build plate better, producing consistent high-quality results.
Timing Belt GT2 200 (#1188)
Cell Board for Up Mini 2 is a spare part for the Up Mini 2 3D printer.
Hot-End Pack for Ultimaker Original (#1587)
This nozzle pack contains 5x the 0.4mm nozzle for the Ultimaker 2+. With this 0.4mm nozzle, you can make high detailed prints. The 0.4mm nozzle is the standard nozzle on the Ultimaker 2+.
V2 Hot End Assembly is a spare part for the Raise3D N2 series 3D printers and N2 Plus series 3D printers.
Limit Switch, Red Wire Ultimaker 3 Extended (#2194)
Front Fan Magnet (#2139)
Print Head Board (#2012)
Hot-End Isolator Coupler (#1055)
Print Head Cable (#1981)
This Ultimaker 3 Maintenance Kit contains all necessary parts to undergo the maintenance seamless and easy.
Please accept cookies to help us improve this website Is this OK? Yes No More on cookies »
U maakt gebruik van een verouderde versie van
Internet Explorer, klik hier om deze te updaten.