Polymaker PolyMax PLA 'True Gray' - 750gr

Polymaker
€ 44,95 Incl. tax

Polymaker PolyMax PLA is an extremely tough filament, with an increased impact strength up to 9 times tougher than other PLA filaments. This plug-and-play material is optimized to print the best results possible both in 1.75mm and 2.85mm filaments.

In stock (8 pieces)
In stock
Article number:
TRIPOLFIL2015
Polymaker PolyMax PLA is an extremely tough filament, with an increased impact strength up to 9 times tougher than other PLA filaments. This plug-and-play material is optimized to print the best results possible both in 1.75mm and 2.85mm filaments. Because of its unique composition, PolyMax PLA does not require a heated bed as such. This remarkable filament offers you the best quality prints.

Tough and warp-free
As said, PolyMax PLA has an increased impact strength, even stronger than some ABS-filaments. With PolyMax PLA you combine the easiness of PLA (easy to use, no hazardous odors and no warping) in combination with the toughness you expect from ABS.

Jam-free
Polymaker created a special technology in its development, which offers a big improvement on the heat stability of its materials. This improvement creates a worry-free print experience.

Recommended printing temperature
1.75mm                 190°C – 220°C
2.85mm                 200°C – 220°C

Recommended printing speed
40 – 90 mm/s
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »
U maakt gebruik van een verouderde versie van
Internet Explorer, klik hier om deze te updaten.
x