Ultimaker Cover Ultimaker 2 Extended+
Protect your special and big prints from warping and other external factors with this Ultimaker Cover. This DIY-kit offers the possibility to upgrade the quality of your Ultimaker prints even more. The Cover makes sure there is a constant heat within the cover. The professional fan and HEPA-filter make sure there is a good air flow.
Some advantages of the Ultimaker cover:
- Constant heat to prevent warping on hard printing material (ABS, PC)
- Air is renewed thanks to a professional fan + Hepa filter
- No more draft when printing
- The cover can be put and remove easily without damaging the printer.
- The printer is even quieter
- No need to screw / make holes/ modify the printer, just need to clip the kit
- A latch is present to close the door and prevent any external access to the printer. No smell or fumes escape from the cover
- Filter can last between 600 to 1200 hours (depending on settings, materials)
The Ultimaker cover KIT is available for the Ultimaker 2 Extended and 2 Extended+
The kit contains:
- 6 PPMA panels (5mm).
- 1 PPMA door (3mm)
- 1 felt for the Bowden tube
- 1 PPMA fixation
- 1 kit of junction parts in ABS
- 1 pack of screws and bolts for assembling
- 1 Filtration Kit
- 1 Power cable (EU Type)
- 1 HEPA filter (H13)
