ColorFabb Corkfill

ColorFabb
€ 39,95 € 27,96 Incl. tax

The newest filamenttype in the gamma of Colorfabb is Corkfill. This filament is based on cork, what makes it more elastic and water resistant than other filaments.

In stock (8 pieces)
In stock
Article number:
TRICOLFIL1S0755
The newest filamenttype in the gamma of Colorfabb is Corkfill. This filament is based on cork. Because of the elements of cork this filament is more elastic and stronger than other filaments. It is also more waterresistant than other filaments.

Because of all of this, Corkfill requires special settings to be printed perfectly. The recommended print temperature lies between 210°C and 230°C. The printspeed is best to be set at 40 to 60 mm/s.

All ColorFabb filaments are produced on transparent spools. It looks awesome and at the same time allows you to immediately see how much filament is left on the spool. We’ll seal the spool immediately after production and then seal the cardboard box again just to be save. This will make sure to keep the moisture out so when you unwrap the spool it’ll be super fresh.

FREQUENTLY ASKED QUESTIONS

So, why don't you use ordinary PLA?

We do use ordinary PLA, but add PHA for better yield at break. It makes our filament less brittle and tougher. This goes for all our filaments, except the transparent ones (green and violet). These are pure PLA.
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »
U maakt gebruik van een verouderde versie van
Internet Explorer, klik hier om deze te updaten.
x